10mm Washable DIP Rotaries
General Specifications
Electrical Capacity (Resistive Load)
Series DR
Switching Rating:
Nonswitching Rating:
Other Ratings
Contact Resistance:
Insulation Resistance:
Dielectric Strength:
Mechanical Life:
Electrical Life:
100mA @ 5V DC
100mA @ 50V DC
80 milliohms maximum for all 4 contacts closed
30 milliohms maximum for 1 contact closed
1,000 megohms minimum @ 250V DC
250V AC minimum for 1 minute minimum
20,000 detent operations minimum
20,000 detent operations minimum
Note: A detent operation is one actuator position operation or stepping.
20,000 detent operations = 1,250 cycles for hexadecimal devices or
2,000 cycles for decimal devices. A cycle is one 360 ° rotation.
Nominal Operating Torque:
Contact Timing:
Materials & Finishes
Shaft & Bushing (DRA only):
Actuator:
Housing & Case:
O-rings:
Base:
Movable Contact:
Stationary Contacts:
Terminals:
Environmental Data
Operating Temp Range:
Humidity:
Vibration:
Shock:
Installation
Mounting Torque for DRA:
Knob Installation Force:
Soldering Time & Temperature:
Process Seal:
Standards & Certifications
Flammability Standards:
UL Recognition
or CSA Certification:
80 ~ 320 grams-cm (1.1 ~ 4.4 ounce ? in)
Shorting (Avoid possible false signal by turning off power before switching.)
Brass with nickel plating
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Nitrile butadiene rubber
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Copper with gold plating
Phosphor bronze with gold plating
Phosphor bronze with gold plating
-25 ° C through +75 ° C (-13 ° F through +167 ° F)
90 ~ 95% for 96 hours @ 40C ° (104 ° F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
50G (490m/s 2 ) acceleration (tested in 3 right angled directions, with 3 shocks in each direction)
1.47Nm (13.0 lb ? in) for double nut; .686Nm (6.08 lb ? in) for single nut
39.2N maximum (8.82 lbf) for DRA model; 29.4N maximum (6.61 lbf) for DRF/DRF2 models
3 seconds @ 350 ° C manual soldering or 5 seconds @ 270 ° C solder pot
See Supplement Index (page Z2) for specific processing data.
UL 94V-0 rated actuator, housing, case, & base
The DR series rotaries have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
NKK Switches ? email: sales@nkkswitches.com ? Phone (480) 991-0942 ? Fax (480) 998-1435
www.nkkswitches.com
8-03
相关PDF资料
5682F7LC;7LC LED T1 DUAL YELLOW/YELLOW PC MNT
6322F33 LED T1 2X4 AMBER/AMBER 602NM PCB
6322F77 LED YEL DUAL T1 PC MNT STACKABLE
DRFR16P SW ROTARY DIP ORN HEX STRGHT PCB
5310F1 LED RED T1 VERTICAL PCB
DRFR10P SW ROTARY DIP ORN DEC STRGHT PCB
5352T3-5VLC LED AMBER T-3/4 RT ANG 5V PCB
DRSC16P SW ROTARY DIP RED HEX STRGHT PCB
相关代理商/技术参数
DRF-NJG-V2W-1 制造商:DOMINANT 制造商全称:DOMINANT Semiconductors 功能描述:High brightness surface mount LED
DRFR10H 功能描述:旋钮开关 SLOTTED BCD R/A RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DR-FR10H 制造商:NKK_SWITCHES 功能描述:
DRFR10P 功能描述:旋钮开关 RO 633-FR01FR10P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DR-FR10P 制造商:NKK Switches 功能描述:DR Series SP10T 0.1 A 5 VDC 10 mm Through Hole Washable DIP Rotary
DRFR16H 功能描述:旋钮开关 RO 633-FR01FR16H RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DR-FR16H 制造商:NKK 功能描述:
DRFR16P 功能描述:旋钮开关 RO 633-FR01FR16P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver